|
11/10/05 - Completed the wiring of the dash and placed 2 connectors near the edge to facilitate installation and removal. It took two 12-pin connectors to handle all the circuits. Another 6 pin connector (not shown) will interface the blinker assembly on the steering column that controls the turn signals and the horn. All circuits in the car are relay controlled so there will be no more than 3 amps on any dash circuit. I added extra weatherstrip cement to the edges of the leather and covered them with aluminum tape as added security against anything coming un-glued later in the summer heat. I've seen this happen on other cars.
| 
view full-size
image -- 1280 x 960)